Latest Updates – July

We look to your feedback to ensure our catalogue is constantly being updated with new tasks or removing out-dated tasks, fine tuned so that your experience is smooth and seamless.

The following changes have occurred to the catalogue!

Catalogue Update:

Plumbing

Code

Heading

Description

DBT0071

REPLACE IPMF in same location

Supply and Install a new induct pipe mica flap (IPMF) above surface level

DJB0070

USE OF WHIPPER HOSE On High Pressure JET BLAST (Includes 1st hour)

Use High Pressure whipper hose in attempt to Clean and Flush small diameter Drain or Floor-waste. –  Access through readily accessible opening. -responsibility will not be held for any subsequent flooding or water damage that may be caused by overflowing drain while jet blasting inside.
Additional charges per 30 mins or part there of will apply after 1st hr onsite

DNP0005

INSTALL/REPLACE First Flush Device

Cut out section of downpipe, install or replace new first flush device, secure/clip to wall. Test and commission

DSD0170

PROVIDE NEW 600 x 600 SURFACE WATER PIT AND 240v, 50mm SUMP PUMP IN GARDEN OR GRASSED AREA

To provide a new 600 x 600 x 600 deep pit with galvanised steel grate to garden or grassed area, provide 50mm submersible pump. Connect  to existing power point within 3 metres and existing stormwater drain within 3 metres.

GAS0001

REPLACE THERMOCOUPLE ON GAS APPLIANCE

Isolate gas supply, disconnect and remove burner assembly, remove existing thermocouple, install new thermocouple to burner assembly. re-install burner assembly. test and commission all work.

GBV0010

REPLACE Existing Gas Ball Valve

Isolate Gas Supply and Remove existing gas ball valve. install new gas ball valve to perform shut-off or isolation. Test and Commission.

GPB0020

INSTALL and Cut In New Gas Ball Valve

Isolate Gas Supply. install new gas ball valve into designated section of pipe to perform shut-off or isolation. Test and Commission.

GUT0040

REPLACE/INSTALL Zinc Rain Water Head

Supply and Install rainwater head in accessible location. Does not include elevated work platform or new gutter and downpipe

HBW0040

INSTALL/REPLACE Under Sink Hot Water Unit

SUPPLY AND INSTALL/ REPLACE Small Hot Water Unit, connecting to readily accessible pipework – includes a general connection kit.

HVV0231

INSTALL/REPLACE isolation Valve To Water Pipe – 15mm

Supply and install/replace ball valve to perform shut-off or isolation in water line.
Isolate water, cut out section of pipe or remove existing valve. install new valve, test and commission.

HVV0241

INSTALL/REPLACE isolation Valve To Water Pipe – 20mm

Supply and install/replace ball valve to perform shut-off or isolation in water line. Isolate water, cut out section of pipe or remove existing valve. install new valve, test and commission.

HVV0251

INSTALL/REPLACE isolation Valve To Water Pipe – 25mm

Supply and install/replace ball valve to perform shut-off or isolation in water line.
Isolate water, cut out section of pipe or remove existing valve. install new valve, test and commission.

HVV0261

INSTALL/REPLACE isolation Valve To Water Pipe – 32mm

Supply and install/replace ball valve to perform shut-off or isolation in water line.
Isolate water, cut out section of pipe or remove existing valve. install new valve, test and commission.

HVV0262

INSTALL/REPLACE isolation Valve To Water Pipe – 40mm

Supply and install/replace ball valve to perform shut-off or isolation in water line.
Isolate water, cut out section of pipe or remove existing valve. install new valve, test and commission.

IRH0010

INSTALL Customer Supplied Room Heater

install customer supplied room heater connecting to existing bayonet/gas outlet.
check correct working of room heater. test and commission all work.

LEA0010

REPLACE/INSTALL Leaf Eater on existing 100mm downpipe

Install leaf eater on existing downpipe, cost includes small section of pipe and adaptors

LEA0020

REPLACE/INSTALL Leaf Eater on existing 90mm downpipe

Install leaf eater on existing downpipe, cost includes small section of pipe and adaptors

OHS0010

INSTALL/REPLACE Outdoor Gas Strip Heater.

Supply and Install/Replace outdoor natural gas strip heater. Includes general adaptors to readily available gas connection. Does not include running of gas pipe.

OHS0020

INSTALL Protective Shield for Outdoor Gas Strip Heater.

Supply and Install heat shield for outdoor natural gas strip heater.

OHS0030

INSTALL Ceiling Mounting Pole for Outdoor Gas Strip Heater.

Supply and Install mounting pole for outdoor natural gas strip heater.

RHSP0010

REPLACE Bayonet Hose for Gas Room Heater

Supply and Replace Bayonet Hose for Heater

RRW0410

Supply & Install/ replace Rain2Main Water Switching Unit

Supply and Install/ replace Rain2Main Water Switching to existing pump.

RRW0420

Supply & Install Rainwater Pump with Rain2Main Water Switching Unit

Supply and Install self-priming stainless steel water pump with Rain2Main Water Switching Unit. Includes concrete base.

RRW0430

REMOVE/ BYPASS Rain2Main Water Switching Unit

REMOVE/ BYPASS Rain2Main Water Switching to existing pump.

SHW0010

REPLACE Solahart Roof Mounted Water Heater

Changeover water heating system – same size & location. Isolate supply services, disconnect hot & cold water and electric circuit, drain the water from existing water heater and remove. Install new HWS and connect hot & cold water. Fill HWS and check for leaks. Commission HWS and clean up

TPG0300

INSTALL 20mm Gas Path Valve and 100mm Access Plate

Supply and install a 20mm gas path valve including 100mm cast iron surface mounted access plate . (Excavation not included).

TPG0301

INSTALL Gas Path Valve (20mm-32mm) and 100mm Access Plate

Supply and install a 20mm – 32mm Gas Path Valve including 100mm cast iron surface mounted access plate . (Excavation not included).

TPG0302

INSTALL Gas Path Valve (40mm-100mm) and 150mm Access Plate

Supply and install a 40mm-100mm gas path valve including 150mm cast iron surface mounted access plate . (Excavation not included).

TTP1421

REPLACEMENT 20mm DOMESTIC WATER METER MAIN TAP TOP

Locate and isolate incoming water supply. Remove top of existing valve. Reseat, and install new top and jumper to existing valve body

Electrical

Code

Heading

Description

xCAPP0001

REMOVE Small Appliance Up to 60cm

Remove and dispose of old appliance in council approved facility. The client is responsible for the clean up, restoration, repair or rectification of the area as a result of removing the old appliance

xCAPP0002

REMOVE Regular Appliance Over 60cm

Remove and dispose of old appliance in council approved facility. May require two men to lift safely. The client is responsible for the clean up, restoration, repair or rectification of the area as a result of removing the old appliance

xCOND0010

INSTALL Conduit (Grey and Orange)

 

xEMB0460

INSTALL Switchboard Link Bar

Install Link Bars in commercial and industrial switchboards

xEREG0010

REPLACE Hotplate Regulator

Supply and Replace Hotplate regulator

xESD1000

INSPECT All Smoke Alarms On The Property

Inspect all smoke alarms on the property and replace any battery deemed close to failure or faulty. Batteries will be included in cost. This does not include the cost of replacing any faulty or non-compliant smoke alarms. A pass or fail with recommendations will be stated on the invoice

xGARD0030

INSTALL LED Deck Lights

Install 6 LED Deck lights. Includes up to 10M of low voltage cable and 12V LED Driver

xPAN0030

SUPPLY LED Panel Frame

Supply new LED Panel Frame

Software Update:

The following updates have occurred to the software

Update

Description

ServiceM8 Update

·         Accepting the quotation Flat Rate NOW to upload into ServiceM8 will now provide a detailed error message in the Management view if it fails to sent back into ServiceM8.

·         When the job is being downloaded in Flat Rate NOW, there was a very small chance that the connection would disengage and you would not be able to upload the accepted quote back into ServiceM8. This has since been fixed to ensure it does not occur.

ABN Always prints on Quote & Invoice

·         The Company Tagline would cause the ABN to disappear on quotations and invoices. This has been corrected to the ABN will always appear.  

Matrix Task Update

·         Matrix Tasks would not correctly calculate without all the relevant information. The error that appeared was not easily understood.

·         The error message is now updated to inform you of what you are missing.

·         Matrix Tasks have been tweaked to calculate faster

Scroll to top

·         When clicking between categories and tasks in the catalogue, the next page would at times load at the middle of the page.

·         The catalogue will now load at the top of the page.

Complimentary Task Update

·         A bug was fixed within the complimentary task feature that stopped the task from being updated to $0.00

·         This has now been fixed

Remember to refresh your software each day to receive the latest updates!

Pin It on Pinterest

Share This